Panini Vision 1 Quick Manual

Step 1: Unpack the Scanner
Before unpacking the box, examine it for
damage received during shipping.
Remove box contents and place the scanner on
a flat surface near the PC.
Make sure that all parts are included:
 Panini Vision 1 Scanner;
 Operator Manual (CD-ROM);
 Quick Guide;
 USB 2 Cable;
 Power Cable;
 Power Supply;
 Ink Cartridge (if ordered with unit).
If the device, or any component, appears
damaged do not use it. File a claim with the
shipping company and contact your reseller
Step 2: Connect the Scanner
Connect the Panini Vision 1™ to your PC
following the steps below:
 Place the device on a level surface near the
host computer.
 Plug the power supply cable in the Vision
1power connector.
 Connect the Vision 1to a dedicated electrical
power outlet.
Ensure that the scanning software and
drivers have been installed
connecting the USB cable to the device.
Connect the USB cable to the USB port located
on the rear side of the scanner, and then
connect the other end of the cable to an
available USB 2.0 port on the PC.
Power Connection USB Interface
Quick Guide
Step 3: Getting Started
If the application program is already installed on
the user workstation, the hardware wizard will
associate the correct preinstalled driver to the
device.
Install the Feeder Extension and fully extend the
Exit Pocket to collect scanned documents.
Pocket Extension
Once you launch your application, the LED will
light-up indicating scanner status.
An application must be started before you
begin to process documents.
Status LED
Off
Solid Green
Solid Yellow
Solid Red
Blinking Red
Step 4: Device Start-Up
Straighten document and remove any staples
and paper clips before feeding.
Do NOT drop a document into the feeder
when yellow processing light is on
Insert one document at a time, right side up with
before
the MICR line aligned to the right.
The inserted document will be detected and
feeding will begin automatically.
The document will be transported, scanned, and
delivered to the exit pocket.
Too many docs in the exit pocket can cause
a jam
Feeder Extension
Status
LED
Description
Offline
Ready to accept and process
a document
Document is processing
Cover is off
Jam or other anomaly
Step 5: Installing Single-Line Ink Jet
Cartridge (Panini P/N: CA-00138)
Open the upper cover and insert the cartridge in
the cartridge nest.
Remove the Ink Jet cartridge
transporting the unit or when the unit will not
be used for long periods. In case the
scanner is not used regularly, periodically
cleaning the ink jet nozzles with a lint-free
cloth is recommended.
Step 6: Clearing Jams
When a jam or error occurs, the paper path must
be cleared.
Remove the documents from the exit pocket and
then free the track by selecting the EJECT
function in your application. In case you are
unsuccessful, apply the following suggestions:
 Extract the jammed document by pulling it out
with your fingers.
 If the document does not pull out, take hold of
the document and pull it down the track to the
first turn, then pull the item up and out of the
transport.
 Occasionally, it may be necessary to remove
the outer cover to free jammed documents.
Step 7: Cleaning and Maintenance
Panini recommends cleaning the Vision 1 weekly
or on an as-needed basis depending on quantity
and condition of the documents processed.
Run a Panini Cleaning Card through the scanner
multiple times, rotating or flipping the card after
each pass.
when