Power On/Off; Turning On The Power - Dukane 8945WU User Manual

Power on/off

Power on/off

Turning on the power

1.
Make sure that the power cord is
firmly and correctly connected to the
projector and the outlet.
2.
Make sure that the PO W E R indicator is
lighted in steady orange (96). Then
remove the lens cover.
3.
Press the S TA ND B Y / O N button on the
projector or the remote control.
The projection lamp will light up and PO W E R indicator will begin blinking in
green. When the power is completely on, the indicator will stop blinking and
light in steady green (96).
To display the picture, select an input signal according to the section S e l e c t i n g a n
i n p u t s i g n a l (23).
The INITIAL SETTING Menu will be displayed by factory default upon startup.
Once the INITIAL SETTING Menu is set, it will not appear until FACTORY RESET
(71) is executed. If you wish to change the settings, refer to the LANGUAGE
(53) and ALTITUDE (67) menu.
(1) LANGUAGE: Use the ▲/▼/◄/►buttons to
select the desired language and press the
E NTE R button of the remote control or the
INPUT button of the projector to execute.
(2) ALTITUDE: Use the ▲/▼ buttons to select
NORMAL for altitude below 1600 m (5250 feet),
otherwise select HIGH and press the E NTE R
button of the remote control or the INPUT button
of the projector to execute.
(continued on next page)
2 0
S TA ND B Y / O N button
PO W E R indicator
INPUT
ASPECT PbyP
MAGNIFY FOCUS
ON
OFF
PAGE
UP GEOMETRY
DOWN INTERACTIVE
ESC
OSD MSG
MYBUTTON
1 2
MYBUTTON
INPUT 1 2
ASPECT PbyP AUTO FREEZE
MAGNIFY FOCUS ZOOM VOLUME
ON + + +
AUTO FREEZE
OFF - - -
PAGE
UP GEOMETRY PICTURE MUTE
DOWN INTERACTIVE NETWORK BLANK
ESC MENU
ZOOM VOLUME
+ + +
ENTER
OSD MSG RESET
- - -
PICTURE MUTE
NETWORK BLANK
MENU
ENTER
RESET