Penton UK Ltd PCL5/T Installation Instructions

ROUND PLASTIC
CEILING
Loudspeaker
PCL5/T
INSTALLATION
INSTRUCTIONS
f
STEP 1
Cut a hole in the ceiling 168mm diameter.
168 Dia (cutout)
Side View
f
STEP 2
Remove the metal grille from the front of the loudspeaker by
pushing all the rotary compression clamps down towards the
grille.
Front View with grille removed
Penton UK Ltd
Unit 2 Teville Industrials
T: +44 (0)1903 215315
www.pentonuk.co.uk
Compression
Clamp
f
Once the grille has been removed connect the 100 volt line
input cable to the required tapping via the terminal block
shown in the circuit diagram.
unit:mm
f
The loudspeaker is ready to be pushed up into the cutout
prepared earlier. Ensure that all compression clamps are fully
extended to allow for the ceiling thickness. Once the
loudspeaker is in position use a cross headed screwdriver
and turning it in a clockwise motion you will observe that the
clamps will pull down and lock the loudspeaker into position.
f
On mounting the speaker replace the snap fit grille.
| |
Dominion Way Worthing
| F:
+44(0)1903 215415
STEP 3
100V COMMON
0.25W
0.75W
1.5W
3W
6W
Circuit Diagram
STEP 4
STEP 5
| |
West Sussex BN14 8NW
| E:
SALES@PENTONUK.CO.UK
ISSUE MAY 2010