Unitronics UniStream USP-070-B10 Installation Manual page 6

HMI Panel Installation Guide
Panel Mounting
 Mounting panel thickness must be less or equal to 5mm (0.2").
N
OTE
 Ensure that the space considerations are met.
1. Prepare a panel cut-out according to the dimensions of your model, USP-070-B10,
USP-104-B10, USP-104-M10 or USP-156-B10 as shown in the previous section.
2. Slide the panel into the cut-out,
ensuring that the Panel Mounting Seal is
in place as shown on the right.
3. Push the mounting brackets into their
slots on the sides of the panel as shown
below.
4. Tighten the bracket screws against the
panel. Hold the brackets securely
against the unit while tightening the
screws.
When properly mounted, the panel is
squarely situated in the panel cut-out as
shown below.
USP-070-B10: 4 mounting brackets
6
USP-156-B10: 10 mounting brackets
USP-104-B10, USP-104-M10 : 8 mounting
brackets
Unitronics