Advertisement
Electrical connection
This heater must be used on an A.C.~ supply only and the voltage
marked on the heater must correspond to the supply voltage. This
heater is fitted with a plug incorporating a 13 amp fuse. When
replacing the fuse, a 13 amp fuse approved by ASTA to BS 1362
must be used.
If the plug is not suitable for the socket outlets in your home, the
plug must be cut off and an appropriate one fitted. A plug cut off
from a mains lead will give a shock hazard if inserted into a 13
amp socket elsewhere in the house. To avoid this, it should be
disposed of immediately.
NOTE: The fuse cover of a non-rewirable plug must be refitted
when changing the fuse. Should the cover become lost, the plug
must not be used until the correct replacement fuse cover is
obtained from your supplier or by contacting our customer helpline.
IMPORTANT : The wires in this mains lead are coloured in
accordance with the following code :
BLUE :
BROWN :
As the colours of the wires in the mains lead may not correspond
with the coloured markings in your plug, proceed as follows :
Connect the BROWN wire to the terminal marked 'L' or coloured
RED. Connect the BLUE wire to the terminal marked 'N' or
coloured BLACK. Note : 'L' or 'N' must not be connected to the
EARTH terminal marked 'E' or ' ' or coloured GREEN or GREEN
AND YELLOW.
If in doubt, consult your electrician.
Using the Heater
Main Elements
- See Fig 1.
1. Power Indicator Light
2. Thermostat Control Knob
3. Switch Knob
4. Air Outlet
Heat Control - see Fig. 2
Fig. 2
Thermostat Control - see Fig. 3
The heat output is controlled by the
thermostat, according to the room
temperature.
Turn the thermostat knob fully clockwise
to maximum setting initially. When the
room is warm enough, reduce the
Fig. 3
setting slowly until the heater just
clicks off.
The heater will now cycle on and off to maintain your
selected room temperature. An audible click may be heard
when the thermostat operates - this is normal.
Note : If the heater does not come on when the thermostat is
at a low setting, this is normally because the room is warmer
than the thermostat setting and is not a fault.
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC)
EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336
[c] Glen Dimplex UK Limited
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex UK Limited.
NEUTRAL
LIVE
-
Off
-
Cool Blow*
-
Half Heat
-
Full Heat
* When the heat control is set to ' ' for cool blow, set the
thermostat control to maximum.
Position ' ' will turn the heater on and off to maintain a
temperature of approximately 5°C.
Safety - overheat protection
For your safety, this appliance is fitted with a thermal cut-out.
In the event that the product overheats, the cut-out switches
the heater off automatically. To bring the heater back into
operation, remove the cause of overheating, then turn off
the electrical supply to the heater for a few minutes.
When the heater has cooled sufficiently reconnect and
switch on the heater.
If the cut-out operates repeatedly, contact your supplier.
Cleaning
WARNING ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powders or polish
of any kind on the heater.
Wipe with a dry cloth to remove dust and a damp cloth (not
wet) to clean off stains. Be careful not to allow moisture
into the heater.
Ensure that dust or fluff does not accumulate inside the
heater as this could lead to overheating of the element.
Use a vacuum cleaner to remove any fluff which does
accumulate.
Recycling
For electrical products sold within the
European Community.
At the end of the electrical products useful
life it should not be disposed of with
household waste. Please recycle where
facilities exist. Check with your Local
Authority or retailer for recycling advice in
your country.
After Sales Service
Your product is guaranteed for three years from the date of
purchase. After sales information or assistance with this
product can be found on our website:
www.dimplex.co.uk/support.
Your rights under this guarantee are additional to your
statutory rights, which in turn are not affected by this
guarantee.
Please do not return a faulty product to us as this may
result in loss or damage and delay in providing you with a
satisfactory service.
If after following these steps your product still does not
operate you should return it to your point of purchase.
Please retain your receipt as proof of purchase.
Advertisement
