Operational Manual
Standard Box Color Camera
Please read the Operational Manual
before attempting to use this product.
FEATURES
1/3" Sony Super HAD CCD
420 TV Lines
0.2 Lux @ F1.2
Lead (Pb) Free RoHS Compliance
Long life and high reliability are achieved by the use
of CCD imaging device. This makes the camera 100%
solid state.
12V DC / 24V AC
DIMENSIONS (Unit: mm)
NOMENCLATURE AND FUNCTION
SST-7420
SST-7420P
1. Lens mount
This mount is used to install a CS-mount lens.
CS-adaptor ring is required if use a C mount lens.
2.
Camera mounting screw holes
Screw hole for fixing camera.
3.
Mount Adaptor
This adaptor can be attached to either the top or bottom of the unit.
4.
Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto iris lens (not supplied) with DC
power and a video signal or DC control signal.
PIN NO.
VIDEO
1
DC + 12V
2
3
VIDEO SIGNAL
4
GND
Control Switch
5.
SW1. SYNC MODE: SYNC Mode Selection INT/L.L. switch.
SW2. AES: Automatic Electronic Shutter OFF/AES switch.
SW3. BLC: Back Light Compensation OFF/BLC switch.
SW4. F.L: Flickerless NOM/F.L switch.
SW5. AGC: Automatic Gain Control OFF/AGC switch.
VIDEO connector
6.
This is an output for connection to a video monitor, etc (75Ω).
7.
Iris mode selection switch
according to the type of your lens.
DC Level adjustment V.R.
8.
Used to adjust video output level of DC
driven auto iris lens.
Power input terminal
9.
Connect the power supply of 12V DC / 24V AC.
CONTROL SWITCH OPERATION
SW1. SYNC MODE: INT MODE: The camera may be operated
independently with its internal crystal control. L.L. MODE: This
version w/o L.L. function.
SW2. AES: AES: The automatic electronic shutter control 1/60(1/50)
~ 1/100.000 sec. is employed for using a manual Iris Lens.
SW3. Example of Back Light Compensation: When the object is
dark by strong light (sun illumination etc) as (Fig 3-1). Please turn
on BLC switch. The object becomes as (Fig 3-2).
DC
CONTROL -
NC
CONTROL +
DRIVE +
DRIVE -
Used to choose DC or VIDEO mode
SST-7420_rev09032008