Advertisement
KNOW YOUR JIG SAW
See Figure 1.
Before attempting to use your saw, familiarize yourself with
all operating features and safety requirements.
WARNING:
If any parts are missing, do not operate your saw until the
missing parts are replaced. Failure to do so could result
in possible serious injury.
VARIABLE SPEED
CONTROL SELECTOR
CHIP
SHIELD
BASE
ELECTRICAL CONNECTION
Your saw has a precision built electric motor. It should be
connected to a power supply that is 120 volts, 60 Hz, AC
only (normal household current). Do not operate this tool
on direct current (DC). A substantial voltage drop will cause
a loss of power and overheating. If your tool does not operate
when plugged into an outlet, double-check the power supply.
OPERATION
LOCK-ON BUTTON
0
TRIGGER
ORBITAL
ADJUSTMENT KNOB
SAW BLADE
Page 5
WARNING:
Do not allow familiarity with your saw to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
APPLICATIONS
(Use only for the purpose listed below)
1. Cutting wood surfaces.
2. Cutting thin sheet metal.
3. Cutting plastics and laminates.
SWITCH
BLADE STORAGE
COMPARTMENT
CHIP SHIELD
A clear plastic chip shield is installed on the front of your
saw for protection against flying dust and chips. The flip-up
design of the chip shield makes installing and removing
blades easier. FOR YOUR PROTECTION, DO NOT USE
SAW WITHOUT CHIP SHIELD PROPERLY IN PLACE.
1/8 in. HEX KEY
HEX KEY STORAGE
COMPARTMENT
Fig. 1
Advertisement
