DeLonghi HFX85W20 Instructions For Use Manual page 10

Change the temperature scale
To change the temperature scale press together the
of temperature buttons (G) and
on remote control, an acoustic signal will be emitted and
the display will show for 3 seconds "F" (Fahrenheit) or"C"
(Celsius) with the simbol .
No beep function
This function allows to activate or deactivate the buzzer
placed on the control panel.
Press together airflow direction button (I) and oscillation
button (J).
The display shows the script "nb" for a few seconds, then the
normal visualization reappears. This function is available in
any operating mode, including standby.
Examples: no beep function
Please note: the buzzer shall generate the sounds
related to the commands "stand-by" and "turning on"
regardless of this function.
Brightness of the display
The appliance allows two different brightness settings for the
display. The highest is active when any key button is pressed.
After a few seconds of keyboard inactivity, the brightness will
decrease to the operating brightness level.
To change the operating brightness level, press the eco
of speed buttons (L)
9
button (H) and timer button (K) together; three brightness
levels are available, the display shows: "L1", "L2", "L3" for 4-5
seconds, and within this time is possible increase or decrease
the brightness level using the speed buttons (L),
respectively.
Elapsed the 4-5 seconds, the last level of brightness selected
will be shown on the display.
Examples: brightness of the display:
Remote control: inserting or replacing the batteries
- The remote control
is provided with
a lithium button
battery CR2032. To
let the appliance
function, remove the
battery cover strip, by
pulling it.
- To replace the
batteries, remove the
battery cover by rotating the screw counterclockwise
with a screwdriver. Replace the battery paying attention
to respect the right polarity as shown in figure.
- Replace the cover rotating the screw clockwise.
- Old batteries must be removed and disposed off in
accordance with current legislation as they are harmful
to the environment.
WARNING: DO NOT DISPOSE OF BATTERIES IN FIRE.
BATTERIES MAY EXPLODE OR LEAK.
Operating from the control panel
To use the unit the remote control is needed.
If the remote control is not available, it's possibile to switch
the operating mode between cooling fan and heating by
means of the ON/STAND-BY button (A) on the control panel.
While the unit is in STAND-BY mode, keeping touched the
ON/STAND-BY button for approx. 10 seconds, the unit is
turned on with predefined setting.
or