Advertisement
Installation
Installation Recommendations
Please read this instruction manual before installing and using this range hood. Keep this
instruction manual in a safe place for future reference.
This range hood can be used either in the Ducted Mode (ducting fumes to the outside) or in the
Recirculation Mode (internal recycling). The choice of modes can be left to customers.
Only a qualified and trained service technician can undertake the work of installation and
servicing. At least two people will be required to mount the range hood.
Check that the mains voltage corresponds to the one indicated on the rating plate fixed inside
the range hood.
Check that the domestic power supply guarantees adequate earthing.
Do not connect the range hood to exhaust ducts carrying combustion fumes (boilers,
fireplaces, etc.).
If the range hood is used in conjunction with non-electrical appliances (e.g. gas burning
appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent
the backflow of exhaust gas. The kitchen must have an opening directly with the open air in
order to guarantee the entry of clean air to the room.
The minimum distance between the supporting surface of the cooking surface for the cooking
vessels of the hob and the lowest part of the range hood must be 650mm. If the installation
instructions for gas hobs specify a greater distance, this must be taken into account.
On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces
of the hood and chimney prior to final installation.
The manufacturer will not be held liable for any damages resulting from incorrect or improper
installation.
Installation position
1.
Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre
of the area in which the range hood will be installed.
2.
Draw a horizontal line at 650mm above the hob.
3.
Place flue cover mounting bracket on the wall as shown about 20mm from the ceiling or upper
limit, aligning the centre (notch) with the vertical reference line.
4.
Mark the wall at the centre of the holes in the bracket.
5.
Place the range hood mounting bracket 6.2 on the wall central to the vertical reference line, with
the hooks aligned upwards.
6.
Mark the wall at the centre of the three holes in the bracket.
7.
Mark two holes on the wall as shown 220mm below the range hood mounting bracket holes for
fixing the range hood body.
8.
Drillφ10mm holes at the seven centre points marked and fit the wall plugs.
Fix the two brackets using the long wall screws.
9.
4
Advertisement
