Download Print this page

Ariston ARCH90BIX Manual

Wall canopy

Advertisement

Quick Links

Description:
ARISTON WALL CANOPY
Model Numbers: ARCH90BIX
1
Model may vary slightly from images pictured.
All measurements are in mm.
RWC
Issue: F

Advertisement

loading

Summary of Contents for Ariston ARCH90BIX

  • Page 1 Issue: F Description: ARISTON WALL CANOPY Model Numbers: ARCH90BIX Model may vary slightly from images pictured. All measurements are in mm.
  • Page 2: Pre-Installation

    Overview Pre-installation Thank you for purchasing a quality Ariston range hood. Ariston has a high standard of quality control and every range hood is tested and approved before it leaves the factory. Important: In certain circumstances electrical appliances may be a danger hazard.
  • Page 3: Appliance Details

    Pre-Installation - continued Typical equipment required:  electric drill, screwdriver, tape measure, spirit level  duct tape, jig saw, ladder (if ducting)  Torch (If natural lighting is insufficient) Contents of packaging: 1x Range hood φ 150mm round ducting 7x Wall Plugs 7x Long Wall Screws 3x Chimney Screws –...
  • Page 4: Installation Recommendations

    Installation Installation Recommendations  Please read this instruction manual before installing and using this range hood. Keep this instruction manual in a safe place for future reference.  This range hood can be used either in the Ducted Mode (ducting fumes to the outside) or in the Recirculation Mode (internal recycling).
  • Page 5 Installation - continued Mounting the Hood Body Mounting to a stud is recommended. However, if fitted to other wall linings (plasterboard, concrete etc) suitable fixings will be required. Before drilling any holes check that the wall and ceiling are clear of any electrical cables, pipes etc.
  • Page 6: Chimney Assembly

    Installation - continued Chimney Assembly Place the chimney bottom onto the range hood body around the outlet (bent edge down). Fix the chimney bottom to the range hood body with the three 12mm screws (from inside the range hood body). Place the chimney top inside the chimney bottom (vents to the top).
  • Page 7: Troubleshooting

    Refit cord to power outlet. Switch disconnected power on Lights not working Broken/ Faulty globes Replace globes (Contact Ariston Service) Insufficient suction The distance between the Refit the range hood to the correct range hood and the gas top is...