Adjustments - Ryobi AG402 Operator's Manual

GUARD ADJUSTMENT
See Figure 6 - 8.
Never use the angle grinder without the guard in place and
properly adjusted.
 Unplug the angle grinder.
 Using the wrench provided, loosen and remove flange
nut, accessory wheel, and disc flange from spindle if
necessary.
 Using a screwdriver, loosen the clamp screw.
 Rotate the guard to its correct position as shown in
figures 6 and 7.
 Retighten clamp screw securely.
WARNING:
Never place the guard so that it is on front of the angle
grinder as shown in figure 8. This could result in serious
injury because sparks and loose particles thrown from the
grinding wheel would be directed toward the operator.
Always place the guard in the correct location as shown
in figures 6 and 7.
DANGER:
Never use your grinder with the guard removed. It has
been designed for use only with the guard installed.
Attempting to use grinder with guard removed will result
in loose particles being thrown against the operator
resulting in serious personal injury.

ADJUSTMENTS

LOCATION OF GUARD IS
BETWEEN POINTS A AND B
12
A
CORRECT
B
INCORRECT
LOCATION OF
GUARD
Fig. 6
Fig. 7
Fig. 8