Instructions - AquaScape 96030 Instruction And Maintenance Manual

Electrical Specifications
Automatic Dosing System
• Input Voltage: 12V AC
• Input frequency: 60 Hz
• Input Watage: 2.5W (max)
• For outdoor or indoor use
• Thermally protected
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
READ AND FOLLOW ALL
1.

INSTRUCTIONS.

2. WARNING - To reduce the risk of injury, do not permit
children to use this product unless they are closely
supervised at all times.
Instructions
Carefully remove the contents
of your dosing system from
the packaging.
1. Attach the transformer to
the dosing system power
cord using the quick-
connect fitting attached to
the system's main power
cord. Please note: the
transformer should be
plugged into a GFCI rated
receptacle. The transformer
included is 12V. The unit
can also be powered by an
existing 12V transformer
used for 12V lighting.
2. Open the dosing system
by pressing the four blue
tabs simultaneously on the
control panel while gently
lifting upward.
4
• This system has been
evaluated for use with the
Aquascape Automatic
Dosing System Water
Treatments only.
2
☎
US 1-866-877-6637 |
Transformer
• Input Voltage: 120V AC
• Input frequency: 60 Hz
• 6-Watts
• For outdoor or indoor use
• Thermally protected
3. DANGER - Risk of Injury.
- Replace damaged cord immediately.
- Do not bury cord.
- Connect to a grounded, grounding type receptacle only.
SAVE THESE
4.
INSTRUCTIONS.
3. Attach the water
treatment pouch by first
removing the existing
water treatment cap.
Then, insert the clear
inner tubing into the
water treatment and seal
the connection using the
threaded cap attached
to the inner tubing. Finish
the pouch installation by
connecting the other end
of the inner tube to the
connection at the bottom
of the control panel.
4. Place the attached
treatment inside the
canister. Then, place the
control panel back onto
the canister.
☎
CAN 1-866-766-3426 | www.aquascapeinc.com
3
4