Advertisement
General Considerations
The receiver should be mounted in a dry location. As a
precaution against stray moisture, the cables should be
installed facing towards the earth.
Metal in the building structure and furnishings may reduce
the sensitivity of the receiver. Please avoid metal-
intensive locations when installing the receiver.
The receiver should be mounted at least 150cm / 59"
above the floor, and 30cm / 11.8" below the ceiling.
A minimum of 20cm / 8" should be maintained between
receivers.
Operating temperature is +10
This is a radio frequency controller operating at 433MHz.
Wiring must be completed by properly trained authorized
personnel.
24hr Technical Support/Customer Service +1.239.206.9115
Phone: +1.239.596.8883 • Fax: +1.239.596.8823 • Toll Free 866.549.0269
*IMPORTANTE
Las garantías no cubren ningún daño a productos MaestroShield® que sean el resultado de instalación inadecuada, accidente, abuso, uso incorrecto,
desastres naturales, suministro energético insuficiente o excesivo, condiciones mecánicas o ambientales anormales, tormentas eléctricas o cualquier
desmontaje, reparación o modificación no autorizados. Las garantías no aplican a ningún producto al que se le haya alterado, destruido o eliminado la
información de identificación, que no haya sido manejado o empacado correctamente, que haya sido vendido de segunda mano, o que haya sido ven-
dido en contra de las regulaciones de exportación de Estados Unidos sin el consentimiento de MaestroShield®. 03/29/2012
Mini-Receiver Wiring Procedures
0
0
0
to +50
C / (50
F to 122
1450 Rail Head Boulevard • Naples FL 34110 USA
www.maestroshield.com
© 2012 MaestroShield
Time Saving Technical Tips
Receivers retain all programming when power is
lost or taken away from the unit. To avoid unne-
cessary delays in-field, it is recommended that all
programming be done prior to taking the units to
the installation site. PLEASE NOTE: to prevent
loss or confusion of the units, insure that each Re-
ceiver is clearly labeled and packaged with its co-
rresponding Remote Controllers.
When preparing on-site locations for installation of
Receiver, have electrician install power outlets
near motor locations and use a cable with a 3-
0
F).
prong power plug to wire the Receiver. Bring po-
wer to the unit by simply plugging the plug into the
pre-installed power outlet.
2
Advertisement
