Harbor Freight Tools 62443 Owner's Manual & Safety Instructions page 9

Using 12 Volt Lights and Accessories
Note: The Charge Controller must be
in "ON" position at all times.
1. If the 12V Lights (16) aren't already
attached to the sockets on the end of
each light wire, gently snap them in.
2. Plug the other end of the 12V Light's wire
into either of the 12 Volt DC outlets on the
Charge Controller as shown in Figure I.
12V Dc 6V Dc
Outlets Outlet
Figure I
3. To turn on and off the lights, flip the
switch on the Light's wire.
Note: You may plug in the each light
into to either 12V DC outlet.
Item 62443
3V Dc
Outlet
For technical questions, please call 1-888-866-5797.
Note: This system can also be used to power
other small 3V and 6V DC small appliances.
4. Plug the appropriate plug on the Multi
Adapter into the appliance. The adapter
has 3, 6, and 12 Volt DC plugs.
5. Insert the plug on the other end of the wire
attached to the Multi Purpose Adapter into the
appropriate DC Outlet on the Charge Controller.
6. Activate your appliance.
cAUTION! Only one appliance can be used at
a time with this adapter and the adapter must
be plugged into the same voltage output.
7. When finished, unplug the Multi Adapter wire
plug from the Charge Controller and then
unplug the Multi Adapter from the appliance.
8. To charge cell phone or other small electronic item,
plug the item's power cored into the USB Port on
the front of the Charge Controller. See Figure I.
9. Use the Inverter Output and the 12V
Female Output ports to connect the male
adapters for 12V accessory items that
need to be charged. See Figure I.
10. To prevent accidents, turn off the appliance
and after use. Clean, then store the
appliance indoors out of children's reach.
Page 9