Specifications; Setup; Operation - Harbor Freight Tools 62443 Owner's Manual & Safety Instructions

Specifications

Rated Output
Open Circuit Voltage
Adapter Outlets
Set Up Instructions
Read the ENTIRE IMpORTANT SAFETy INSTRUcTIONS section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Make sure that the power Switch/Trigger is in the off-position and unplug the tool
from its electrical outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Installation
Location
1. Locate the Solar Panels (12) where they will
receive full, unobstructed sunlight, especially during
midday. Nearby trees or tall plants will drop debris,
requiring the panels to be cleaned more frequently.
Mounting
1. Select a mounting location for the Solar Panel
Kit. The Solar Panels should face the Sun, and
not be blocked by shadows. The location should
allow the Panels to be protected from accidental
damage. The location should be flat, stable and
able to support the weight of the Solar Panel
Kit's accessories. Before assembly, be sure
that all accessory cables reach their connection
points without placing any stress on the wiring.
Item 62443
14.5 V~ / 15 W (per solar panel)
23.6 OCV
3, 6, and 12 VDC
For technical questions, please call 1-888-866-5797.
2. The setup location for the Solar Panel Kit must
be inaccessible to children to prevent electric
shock. Build a childproof enclosure if needed.
3. Install the charge controller/regulator and batteries
in a weatherproof enclosure with proper ventilation.
2. Angle face of Solar Panel Frame toward true
1
south according to chart that follows:
Latitude Solar panel Angle
0-4° 10°
5-20° Latitude + 5°
21-45° Latitude + 10°
46-64° Latitude + 15°
65° or more 80°
1
Angle towards true north if installed
in southern hemisphere.
Page 5