Micro 6888 Operation Manual

#6888

LOCK BUTTON

• Press and release the LOCK button to ARM ALARM
and LOCK DOORS
• Press and release the LOCK button to LOCK DOORS
• Press and release LOCK button and press it again for
2 SECONDS to BYBASS SHOCK SENSOR and ARM
ALARM (Use this to bypass shock sensor)

UNLOCK BUTTON

• Press and release the UNLOCK button to DISARM
ALARM and UNLOCK DOORS
• Press and release the UNLOCK button to STOP
ALARM TRIGGER
• Press and release the UNLOCK button to UNLOCK
DOOR
• Press and Hold the UNLOCK button for 2 SECONDS
to switch ALARM to KEYLESS basic mode.

PANIC BUTTON

• Press and hold the PANIC but-
ton for 2 SECONDS to TRIGGER
HORN / SIREN

AUX BUTTON

• Press and release the AUX button for TRUNK
RELEASE
• Press and hold the AUX button for 2 SECONDS for
SILENT ARMING and Lock Doors
• Press and hold the AUX button for 2 SECONDS for
SILENT DISARMING and Unlock Doors

VALET OVERRIDE SWITCH OPERATION

1. Stopping horn/siren: Turn ignition on, press and hold valet switch until horn/siren stops.
USED FOR:
2. To enter/exit keyless basic mode (LED steady on): Ignition on and hold valet switch for 5 seconds.
3. Use to program remotes: Turn ignition on, press and release valet switch 5 times, press lock buttons on
each remote to be programmed, turn ignition off. Up to 4 remotes may be programmed.
Most Common Locations (Ask installer where it is located.)
• Inside glove compartment, driver's kick panel, behind the
fuse panel access door, underneath
the dashboard in front of the driver.
The button operations shown are a general guide. Consult with the dealer that installed your keyless entry to confirm these remote functions.
REMOTE OPERATION GUIDE
REPLACEMENT REMOTE PART NUMBER: #REMOTE-6888
THIS IS ONLY A GUIDE
©2011 Micro Alarm Systems, Inc. • 6888-Op-oct2011.indd
Ignition must be OFF
During Valet Mode
Ignition must be OFF
Alarm must be ARMED and
Ignition OFF
When siren / horn is Sounding
During Driving or Valet Mode
Alarm must be DISARMED
and Ignition ON.
2nd AUXILIARY
LOCK
• Press LOCK and PANIC buttons
PrESS
TOGETHEr
together to get AUX2 Output.
Note: Contact installer to make sure this
PANIC
option is enabled.
Alarm must be DISARMED
and ignition OFF
Alarm must be ARMED and
ignition OFF