8_Cooling Mode - Williamson-Thermoflo 9SRA-HE Owner's Manual

Cooling mode icon
Mode
button
Fan speed
adjustment
button
CAUTION:
Set a reasonable temperature to avoid discomfort from overcooling.
In cooling mode, you can adjust the following :
- temperature
- fan speed (low, medium, high, automatic)
- airflow direction
1. Press the ON/OFF button to start the air conditioner.
2. Press the MODE button repeatedly until the cooling mode icon
( ) is displayed in the upper left corner of the remote control.
3. Press the fan speed adjustment button (
speed (low, med, high, auto).
4. To adjust the temperature, press the WARMER/COOLER buttons
until the targeted temperature is displayed. The available temperature
range is between 61 °F (16 °C) and 87 °F (31 °C).
Temperature
adjustment
- Each time you press a WARMER/COOLER button, the temperature
buttons
is adjusted by 1 °F or 1 °C.
Airflow
directional
5. The air conditioner starts cooling, provided that the room
button
temperature is higher than the selected target temperature.
Airflow
sweep
button Note:
- If the room temperature is lower than 61 °F (16 °C), the air conditioner
will not allow the compressor to operate in cooling mode.
- If the room temperature is too low and the room humidity is too
high, frost or ice can form on the surface of the evaporator.
However, the air conditioner is pre-adjusted to protect itself against it.
Whenever the evaporator temperature drops below 30 °F (-1 °C), the
outdoor unit will stop running until the evaporator temperature
increases to 45 °F (7 °C).
8_ COOLING MODE
) and select the desired
Owner's manual _8