Table of Contents
Advertisement
Quick Links
DATA DISPLAY GROUP
ARCBII
USB and RS485 Installation
Guide
Remote Control and Diagnostic Board
Product No: PA-18-000, PA-18-001
The information contained in this document has been carefully researched and is, to the best
of our knowledge, accurate. However, we assume no liability for any product failures or
damages, immediate or consequential, resulting from the use of the information provided
herein. Our products are not intended for use in systems in which failures of product could
result in personal injury. All trademarks mentioned herein are property of their respective
owners. All specifications are subject to change without notice.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Data Display Group PA-18-000
- Page 1 USB and RS485 Installation Guide Remote Control and Diagnostic Board Product No: PA-18-000, PA-18-001 The information contained in this document has been carefully researched and is, to the best of our knowledge, accurate. However, we assume no liability for any product failures or damages, immediate or consequential, resulting from the use of the information provided herein.
-
Page 2: Table Of Contents
DATA DISPLAY GROUP Table of Contents 1 Revision History ....................3 2 RS485 Network Installation .................. 4 Network Topology ..........................4 Start Up Protocol...........................4 Cabling..............................5 2.3.1 Cabling for system without External RS485 Converter ................5 2.3.2 Cabling for system with External RS485 Converter ................5 3 RS232 and USB Setups.................. -
Page 3: Revision History
DATA DISPLAY GROUP 1 Revision History Date Description Exp. 10/11/09 First Release Page 3 of 8... -
Page 4: Rs485 Network Installation
DATA DISPLAY GROUP 2 RS485 Network Installation 2.1 Network Topology First device on the RS485 bus is named as “Master ARCB”. Master device has its specific settings which is different than other ARCBs on the bus. All other ARCBs are named “Slave” on the bus. Master device can be connected to PC either RS232, USB or RS485 connections. -
Page 5: Cabling
DATA DISPLAY GROUP 2.3 Cabling Two main configurations are possible: 2.3.1 Cabling for system without External RS485 Converter All cables are same and “1-to-1”. • Pin 1 and 2 should be twisted pair cable for all connectors • Pin 3 and 4 should be twisted pair cable for all connectors •... -
Page 6: Rs232 And Usb Setups
DATA DISPLAY GROUP 3 RS232 and USB Setups 3.1 RS232 Setup No setup or driver installation is required for RS232. 3.2 USB Setup USB communication with ARCB needs driver installation to operating system. Follow these steps: 1- Download the driver packet which proper for the operating system in your PC. - Page 7 DATA DISPLAY GROUP 5- Click “OK”. Then following message will appear, click to “Continue Anyway”: 6- Installation completed. Check the “Device Manager” to be sure of successful installation: 7- Restart the PC. 8- Do the following adjustments: 9- Finished. Page 7 of 8...
- Page 8 Our company network supports you worldwide with offices in Germany, Great Britain, Turkey and the USA. For more information please contact: Distec GmbH FORTEC Elektronik AG Augsburger Str. 2b Lechwiesenstr. 9 82110 Germering 86899 Landsberg am Lech Germany Germany Phone: +49 (0)89 / 89 43 63-0 Phone: +49 (0)8191 / 911 72-0...
Need help?
Do you have a question about the PA-18-000 and is the answer not in the manual?
Questions and answers