Installation Instructions - Breeze 3030SR Instruction Manual

Installation Instructions

Inspection of Shipment:
After unpacking, check thoroughly for any damage which may have occurred in transit.
Claims should be filed immediately with the transportation company. The warranty
does not cover damage that occurs in transit or damage caused by abuse or
consequential damage due to the operation of this machine, since it is beyond our control.
Your Floss Machine warranty is described on the back page of this manual. This does
NOT cover the motor bearings, since they can be damaged by the operator.
Electrical Requirements:
The following power supply must be provided:
Model No. 3030, 3030SR, 3040 and 3040SR:
Model No. 3030EX:
.
Your electrician must furnish sufficient current for proper machine operation. We
recommend this floss machine be on a dedicated and circuit protected line. Failure to wire
properly will void the warranty and can result in damage to the heat elements, motor and
etc.
It is Gold Medal Products Company's recommendation that this machine be plugged directly
into a wall outlet. The use of extension cords is not recommended due to safety concerns
and the floss machine's performance may be sacrificed/reduced.
Before You Plug in Machine
Remove all padding and restraints.
Turn the two shipping knobs located around the motor mount casting counter-clockwise.
This will allow the motor mount casting to "float" freely on the springs. Note: This step
Is not necessary for the 3040SR.
120 VAC, 60 Hz, 15 Amps
240 VAC, 50 Hz, 15 amps
3
Models: 3030, 3030SR, 3030EX, 3040 and 3040SR
The Breeze