Addonics Technologies DIEDES Installation Manual

Addonics
T E C H N O L O G I E S
Diamond ExDrive
DSAEDES & DIEDES
DSAEDEU & DIEDEU
User's Guide
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
Version 1.0
Hardware Installation Guide
Step 1
Use a Philips screwdriver to
turn the cover securing
screw into the "OPEN"
position.
Step 2
Slide the aluminum cover
towards the back end of the
Diamond and remove it.
Step 3
For SATA Drive
Carefully place the SATA hard drive
with the label facing up into the
Diamond enclosure. Push the hard
drive towards the back end to secure
the drive connectors onto the
Diamond enclosure's SATA
connector.