DESCRIPTION Auto-off indicator light* Spray nozzle Cord Filling inlet Handle Variable steam control Thermostat control light Dry ironing Temperature control dial Steam max. position Water tank Anti Calc Maximum water level indicator Spray button Soleplate Burst of steam button IMPORTANT SAFETY INSTRUCTIONS When using an iron, basic precautions should always be followed, in- cluding the following:...
9. To avoid a circuit overload, do not operate an iron on the same circuit with another high wattage appliance. 10. If an extension cord is absolutely necessary, a cord with an am- pere rating equal to or greater than the maximum rating of the iron shall be used.
1 • What water may be used ? Your iron has been designed to operate using untreated tap water. If in doubt, check with your local water authority. However, if your water is very hard, you can mix 50% untreated tap water with 50% distilled or demineralised water. IMPORTANT Heat concentrates the elements contained in water during evaporation.
TIP Always spray starch onto the reverse side of the fabric to be ironed. 4 • Dry ironing Set the variable steam control to (fig.11) and set the temperature to suit the type of material (care points •, ••, •••). 5 •...
MAINTENANCE AND CLEANING IMPORTANT Unplug and allow the iron to fully cool down before maintenance and cleaning. 13 • Anti-scale system Your iron contains an anti-scale cartridge to reduce scale deposits. This considerably prolongs the operational life of your iron. The anti-scale cartridge is an integral part of the water tank and does not need to be replaced.
control into the Anti Calc position (fig.5) : steam will now begin to build up. After a few seconds water will emerge from the soleplate, rinsing dirt and scale particles out of the steam chamber. Move the steam control to position after approx. 1 minute. Plug in the iron and allow the iron to heat up again.
Page 11
PROBLEMS? Problems Cause Solution The iron is plugged No mains supply. Check that the mains plug is properly in, but the soleplate inserted or try plugging the iron into a of the iron remains different socket. cold. Temperature control set Set the temperature control to a higher too low.
Need help?
Do you have a question about the DW7180 and is the answer not in the manual?
Questions and answers