Operating Your Wine Cooler - Vinobox 24 Design Instruction Manual

encountered, it is your responsibility and obligation to have it replaced with a properly
grounded 3 pins wall outlet.
The cord should be secured behind the appliance and not left exposed or dangling to
prevent accidental injury.
The appliance should always be plugged into its own individual electrical outlet
which has a voltage rating that matches the rating label on the appliance. This
provides the best performance and also prevent overloading house wiring circuits that
could cause a fire hazard from overheated. Never unplug the appliance by pulling the
power cord. Always grip the plug firmly and pull straight out from the receptacle.
Repair or replace immediately all power cords that have become fray
Ed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage
along its length or at either end. When moving the appliance, be careful not to damage
the power cord.
Electrical fuse protection of at least 10 amperes must be provided. If the socket is no
longer accessible once the appliance has been built-in, suitable measures must be
taken during electrical installation to ensure that the appliance can be disconnected
from the mains.
Do not use your appliance with an extension cord unless this cord has been checked
and tested by a qualified technician or service person. The extension cord must be a
VED-Listed, 3 wire grounding extension cord that has a grounding plug and outlet
and that the electrical rating of the cord is 220-240 volts and at least 10 amperes.

Operating Your Wine Cooler

The Wine cooler should be placed in a position where the ambient temperature is
between 0-38℃/32-100℉. Humidity level is between 45~90%. If the position is
above or below this range, the performance of the unit may be affected. For example,
placing your unit in extreme cod or hot conditions may cause interior temperature to
fluctuate.
NOTE:
l When you use the wine cooler for the first time or restart the wine cooler after
having been shut off for a long time, there could be a few degrees variance
between the temperature you select and the one indicated on the LED readout .
This is normal and it is due to the length of the activation time. Once the wine
cooler is running for a few hours everything will be back to normal.
l If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the wine
cooler will not start.