Table of Contents
Advertisement
Setting the Temperature Control
You can select temperature display setting from Fahrenheit to Celsius degree b
touching the ℃ /℉ Selector mark. Fahrenheit or Celsius degrees indicator will appear
in blue color in the temperature display window for each zone. You can set the
temperature as you desire by touching the UP and DOWN marks. When you touch the
two marks for the first time, the LED readout will show the original temperature set
previously.
l The temperature that you desire to set will increase 1 ℃ or 1 ℉ if you touch the UP
mark once, on the contrary the temperature will decrease 1 ℃ or 1℉ if you touch
the DOWN mark once.
l Temperature range : 5-18℃/41-64℉,
l The temperature inside the unit will be appeared in blue color in the display
window.
Shelves
l To prevent damaging the door gasket, make sure the door is fully open when
pulling shelves out of the rail compartment.
l For easy access to the bottles stored, pull the shelves out approximately 1/3.The
shelves are designed with an emergency stop to prevent the being removed too far
when loaded.
l The shelves has been designed so that a range of shelf height can be selected. All
the shelves can be adjusted.
Defrosting
l The unit defrosts automatically.
l The evaporator behind the rear wall of the unit defrosts automatically. The
condensate collects in the drainage channel behind the rear wall of the unit, and
flows through the drainage hole into the drip tray by the compressor where it
evaporates.
Storage
l Many bottles may differ in size and dimensions. As such the actual number of
bottles you may be able to store may vary.
Advertisement
Table of Contents
