Reversing The Door - HELLER RBF92 Instruction Manual

REVERSING THE DOOR

WARNING!: When reversing the door, the appliance must not be connected to the mains. Remove the
plug from the mains beforehand.
The door opening can be reversed from "right hand hinged" to "left
hand hinged" if required. If your appliance is supplied "left hand
hinged" simply reverse the following procedure.
STEPS:
•
Remove the retaining screws and the Top Hinge (2)
•
Remove the plastic Upper Hinge Cover (1)
•
Lift the door off the Lower Hinge (4).
•
Remove the retaining screws and the Lower Hinge (4)
•
Remove the Hinge Pin and Foot from the Lower Hinge (4), turn
the hinge over and refit the Hinge Pin and Foot.
•
Remove the Foot (5) from the left hand side and refit on the
right hand side. Now fit the Lower Hinge (4) to the pre-drilled holes
on the opposite side of the cabinet
•
Now fit the Lower Hinge (4) to the pre-drilled holes on the
opposite side of the cabinet
•
Remove the Plastic Caps (6) from the top left hand side and refit
on the right hand side.
•
Locate the Door (3) onto the Lower Hinge (4) and refit the Top
Hinge.
•
Ensure that the door closes and seals correctly – tighten all the
screws.
•
Refit the Top Hinge Cover (1) .