HELLER RBF92 Instruction Manual page 3

•
Be sure that no other high current appliances are plugged into the same circuit as your appliance, as an
overload can occur.
•
Avoid the use of an extension cord as the extension cord may overheat and cause a risk of fire.
•
Do not use the appliance for other than its intended use.
•
Do not use outdoors. FOR INDOOR USE ONLY.
•
If positioned next to another fridge or freezer, leave a minimum gap of 2cm between the appliances in
order to avoid condensation.
•
A clearance of 50mm should be left above the appliance. If this cannot be achieved you should ensure a
clearance of 25mm is maintained on each side of the appliance.
•
Please ensure that there is a small 'air-gap' between the condenser on the rear of the appliance and the
rear wall.
•
Do not place or store heavy items on the top of this appliance.
•
Ensure that the appliance is positioned upright on a firm flat floor, so that the cabinet is stable.
•
This appliance must be level. Adjust the level by screwing the adjustable feet up or down (use your fingers
or a suitable spanner).
•
Your old appliances contain insulation gases and refrigerant that must be disposed of correctly. Please
ensure that the refrigerant circuit is not damaged before the appliance is taken away for correct disposal in
line with current legislation. If there is any doubt contact your Local Authority for instructions.
•
If using an adaptor, this must be used in accordance with the manufacturer's instructions and ensure that
the electrical circuit is not overloaded as this could cause overheating.
•
Do not twist or bend the cables, and keep them away from hot surfaces.
•
Do not plug in or unplug this appliance with wet hands.
•
Make sure that the power cable is not trapped underneath the appliance.
•
Allow the appliance to stand for a minimum of 4 hours after installation. Plug in the appliance and switch
on at the mains supply.
•
Set the thermostat control to the required setting as detailed in the Temperature Control section on the
instruction manual.
•
Leave the appliance for approximately 4 hours for the correct temperature to be reached.
•
Place the appliance close to the wall with a distance not exceeding 75mm
•
Locate the appliance in a cool well-ventilated room and make sure that the air vents are clear.
•
Try to avoid keeping the door open for a long time, warm air will enter the cabinet and may cause a build
up of ice, as well as affecting the energy consumption. Ensure there are no obstructions preventing the
door from closing properly.
•
Ensure that the door seal is clean and there are no tears or splits.
•
Keep the most perishable foods, (those with a short shelf-life, such as cooked meats), in the coldest part of
the fridge. The Salad Crisper Box is the warmest part of your fridge and should be used for vegetables,
salads and fruits etc. (see Description of Appliance on Page 4).
•
Do not overload the fridge: the cooling air that circulates to keep the fridge cold gets blocked and pockets
of warm air form.
•
If there is a power failure, keep the door closed. When the power has been restored the appliance will start
to operate, but it may take some time to achieve the pre-set operating temperature. Check the condition
of your stored food items and liquids.
•
This appliance contains the refrigerant isobutene (R600a). This is a natural gas with a high level of
environmental compatibility and flammability; however, caution is required as isobutene is a flammable gas.
It is essential that refrigerant tubes are not damaged during transportation.
•
Do not damage the refrigerant coil.
•
The use of attachments or accessories not recommended or sold by the product distributor may cause
personal or property hazards or injuries.
•
This product is intended for normal domestic/household use only.
•
Use this unit as described in this manual. Any other uses, not recommended by the manufacturer, may
cause fire, electric shock, or injury to persons and may void the warranty.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety.