Smart Lock; Product Maintenance - Fellowes AutoMax 550C User Manual

ADVANCED PRODUCT FEATURES
Auto Reverse
Stops and reverses paper
if a jam occurs.
SMARTLOCK
Optional 4-digit SmartLock
shredding cycle.
ENGAGE SMARTLOCK
1 2
Open lid and add paper
Close lid and press
Lock icon
4 5
Press start ( ) to When shred job is
begin shredding
complete, Lock icon will
turn off and shredder
will unlock
NOTE: • To unlock: press lock icon and re-enter previously set 4-digit lock combination.
• In case of a power outage, SmartLock™ will remain engaged. Once power is restored, shred cycle will automatically resume.
• If shredder misfeeds or jams, the shredder will unlock after 30 minutes.
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Open lid *Carefully apply oil
across cutters (do not
get oil in paper tray)
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
4
SmartLock™
Engages with each shred cycle to
protect confidential information.
TM
feature keeps confidential documents secure during
TM
3
Enter 4-digit lock combination
on pin pad. Drawer will lock
and Lock icon on control panel
will illuminate
3
Close lid. Press
start ( )
15
SilentShred™ Technology
Shreds without noisy disruptions.
WHEN IN SLEEP MODE
To get out of sleep, open
lid and load paper
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: the paper detection sensors are located in the center of the paper entry and bottom of paper tray).
TO CLEAN THE SENSORS
2
1
Turn off and unplug
Open lid
shredder
5
4
Using cotton swab, wipe away any
Dip cotton swab in
contamination from the paper sensors
rubbing alcohol
Energy Saving Sleep Mode
Feature shuts down the shredder
after 2 minutes of inactivity.
SLEEP MODE OPERATION
Feature shuts down the shredder after
2 minutes of inactivity
1 2
or Insert paper
3
Locate Auto-start infrared sensor