Sylvania D6 Installation Manual page 8

Note:
 Additional hardware is required to mount LED Retrofit Kit in fixture
 Re-use screws previously holding HID ballast to fixture to attach Retrofit Kit.
 For Post Top fixtures, PART-A should be installed as high as possible maintaining the minimum distance shown in Section 1.3
 For Type-III, ensure "Street Side" labels on side of heat-sink and optics face street side
 55 W model power supply shown in images above


CENTER POLE MOUNTING
Power Supply Down
Street Side Direction
Label should point
towards the street
Post-Top
Power Supply Up
Post-Top