Sylvania D6 Installation Manual page 7

Note:
 Mounting height can be regulated using locking nut.
 To attach mounting disk, remove insulation block from top of power supply and re-mount using same screws.
 Route DC pigtail down PART-H (mounting pole).
 Allow at least 1" space around PART-A from fixture.
 PART-H may be altered per specific fixture requirements by the following guidelines
Cutting and rethreading ½" NPT side of PART-H: Minimum overall conduit length not to be less than 5 inches
o
Extending using standard ½" metal electrical conduit fittings: Maximum overall conduit length not to exceed 30
o
inches
Bending of PART-H: Bending should not cause PART-A to be within 1" of fixture
o
 Product ships configured with power supply up; insulation block must be mounted on disk when used in configuration with
power supply down.
2.3. STEP 3: Install retrofit kit in fixture
SIDE BRACKET MOUNTING
 For a post-top fixture
B F
Note: Screws used to mount LED module and power supply
in fixture are existing screws from previous HID system.
A