Advertisement
A 2380 REDBACK
™
Speaker Distribution System
Installation Instructions.
1. Select a convenient mounting location for the A 2380.
2. Run all the necessary wiring to the A 2380. It is a good idea to label the wires for future reference.
To make the connections to the A 2380:
a. Remove the speaker terminal blocks from the P.C board.
b. Strip approximately 10mm of insulation from the end of each speaker wire.
c. Tightly twist the end of each wire.
d. Insert the speaker wires into the output terminal blocks (marked "speaker") and tighten the
grub screws.
e. Insert the wires from the amplifier output into the A 2380 input (marked "amplifier") and tighten
the grub screws.
f. Plug the speaker terminal blocks into the P.C. board.
4. Make sure that all connections between your amplifier and the A 2380 are "phase correct"
(Positive to positive and negative to negative)
5. Make sure that all connections between the A 2380 and the speakers are "phase correct"
6. Make sure the volume control on your amplifier is turned down to minimum.
7. Turn amplifier on and slowly turn the volume control up to the desired level.
1
2
3
4
( Top View)
Page 4
5
6
7
8
9
10
Receiver
/ Amplifier
R.
L.
Advertisement
