Table of Contents
Advertisement
T e c h 3 0 0
Stationary Relearns:
Stationary Relearns use the vehicle on-board TPMS system to listen for transmissions from
TPM sensors while the vehicle is in a "Learn Mode".
Once the vehicle is in Learn Mode, use the TPMS tool to activate the sensors. The vehicle will
listen for the sensor IDs and learn them to the vehicle.
Active (Drive) Relearns:
Some vehicles can be reset by driving. Refer to the on-screen relearn procedures for details on
how far/long to drive. It can take up to 20 minutes to relearn the TPM IDs.
OBD Relearns:
OBD connection allows the TECH300 to directly program the vehicle electronics module with
TPM IDs.
Note that not all vehicles support vehicle communications modes.
OBD can be connected when all sensors are successfully read and the message "All Sensors
OK" is displayed.
Please use the "View Vehicle Information" menu and select "View Vehicle Info" to find the OBD
location.
To perform a relearn read all 4 wheels. If one or more sensors are faulty, please use the 'Relearn
Toolkit'.
Navigate with the Down Arrow to the 'Relearn Toolkit' then 'Program Sensor' and select the
programmable sensor. The instructions can be found above in the corresponding paragraph
('Program Sensor').
Relearn Toolkit
User Guide R.55.2
Universal Sensors
EZ-Sensor
IntelliSens
Sensit.it
1/3
13 |
P a g e
Relearn Toolkit
Program Sensor
OBD
Sensor Search
UHF Monitor
1/4
2 0 1 7
Advertisement
Table of Contents
