AMERICANA OZARK Assembly Instructions Manual

AMERICANA OZARK Assembly Instructions Manual

Door canopy

Advertisement

Quick Links

Recommended Tools:

Before You Begin:

Level, Pliers, 3/8" Electric Drill, Carpenters Square, Tape Measure, Metal Hack Saw,
Silicone Caulking, Screw Drivers (Regular & Phillips)
1.) Please read all instructions carefully. Check the Bill of Materials for any missing parts,
and gather all necessary tools. The paint finish can be scratched so place materials
on tarp or cardboard to prevent scratching.
2.) Note that this patio cover kit is not designed to carry additional loads such as hanging
plants, swings, people, trellis's, or other objects.
OZARK DOOR CANOPY
ASSEMBLY INSTRUCTIONS
Rev'd. - 7/07/09

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OZARK and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AMERICANA OZARK

  • Page 1 OZARK DOOR CANOPY ASSEMBLY INSTRUCTIONS Recommended Tools: Level, Pliers, 3/8" Electric Drill, Carpenters Square, Tape Measure, Metal Hack Saw, Silicone Caulking, Screw Drivers (Regular & Phillips) Before You Begin: 1.) Please read all instructions carefully. Check the Bill of Materials for any missing parts, and gather all necessary tools.
  • Page 2: Parts List

    Contact Us at: OZARK DOOR CANOPY (800)851-0865 or PARTS LIST www.americana.com 1. Awning Rail 3. 1 1/2" x 1 1/2" Post 2. Wall Mounting Channel 6. Roof Panel 4. Front Gutter 5. Side Fascia 7. Top Post Bracket 10. Scupper 9.
  • Page 3 STEP 1. -Drill 1/4" dia. holes beginning 2" from either end at 12" to 16" on center in awning rail as shown (see Fig. 1-1). -Slide awning rail onto wall channel and apply a generous bead of silicone to backside of awning rail (see Fig 1-1). Note: Center to center dimension of 1/4"...
  • Page 4 STEP 2. -Attach post brackets to top of post using 2 - #8 x 3/4" Tek Screws (see Fig. 2-1). Upper Post Bracket Post #8 x 3/4" Tek Screw Fig. 2-1 -Cut post to proper length. Posts must reach from front gutter at desired angle back to the structure. -Be sure to give the cover a subtle slope to drain water towards the front gutter.
  • Page 5 STEP 3. -Use a ladder with any type of shim to support the front of the roof panels while the rear half is attached to the wall channel (see Fig 3-1). -Do not secure front half of roof panels to gutter until all roof panels are attached to wall channel. -Working from underneath, attach roof panels to the wall channel with #8 - 32 x 1/2"...
  • Page 6 STEP 4. -Attach one end of projection fascia to the wall channel with 2 - #8 x 3/4" screws from the top of fascia (see Fig. 4-1). -Attach the other end of the projection fascia to the gutter by caulking & installing corner caps with 4 - #8 x 3/4" screws (see Fig.
  • Page 7 1 1/2" Lag Bolt, Typ (Anchors if Req'd) Fig. 6-1 Fig. 6-1 Fig. 6-2 ASSEMBLY COMPLETED Other Products Available from Americana: Fabric & Aluminum Awnings - Carports - Patio Covers - Room Enclosures - Park Shelters Check Out Our Web Site @ www.americana.com...

Table of Contents