AEG IKE95471FB User Manual page 20

20 www.aeg.com
Problem
The hob deactivates.
Residual heat indicator does
not come on.
Hob²Hood does not work.
Automatic Heat Up does not
operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
The flexible induction cook-
ing area does not heat up
the cookware.
comes on.
comes on.
Possible cause
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time or the sensor is dam-
aged.
You covered the control
panel.
The zone is hot.
The highest heat setting is
set.
Power management oper-
ates.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated.
The cookware is in a wrong
position on the flexible in-
duction cooking area.
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
Remedy
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Remove the object from the
control panel.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Refer to "Daily use".
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer to
"Daily use".
Place the cookware in the
correct position on the flexi-
ble induction cooking area.
The position of the cook-
ware depends on the activa-
ted function or function
mode. Refer to "Flexible in-
duction cooking area".
Use cookware with a diame-
ter applicable to the activa-
ted function or function
mode. Use cookware with a
diameter smaller than 160
mm on a single section of
the flexible induction cook-
ing area. Refer to "Flexible
induction cooking area".
Refer to "Daily use".
Put cookware on the zone.