Brother P-touch PT-E105 User Manual page 15

What to do when
Problem
The display • Check that the batteries are
remains correctly installed. Refer to the
blank after Installing Power Supply and
you have Tape Cassette section.
turned on
• The batteries may be weak.
the P-touch
Replace them.
labeling
• Check that the AD24 Adapter is
system.
correctly connected.
When the
label is
• Refer to the Setting Margins
printed,
section in this guide and select
there is too
much [Half] , [Narrow] or [Chain
margin
Print] to have smaller margins for
(space) on
your tape.
both sides
of the text.
The P-touch
labeling
• Check that the cassette is inserted
system
does not
correctly.
print, or the
• If the cassette is empty, replace it.
printed
• Check that the Tape Cassette
characters
are not
Cover is closed correctly.
formed
properly.
The setting • The batteries may be weak.
has cleared Replace them.
on its own.
• When power is disconnected for
more than three minutes, all text
and formats in the display settings
are cleared.
A blank • There may be some dust on the
horizontal Print Head. Remove the cassette
line appears and use a dry cotton swab to gently
through the wipe the Print Head with an up-and-
printed down motion. Refer to the
tape. Installing Power Supply and
Tape Cassette section in this guide
for the Print Head location.
Solution Problem
The P-touch
labeling
system has
"locked up"
(i.e., nothing
happens • Refer to the Resetting the P-touch
when a key Labeling System section in this
is pressed, guide.
even though
the P-touch
labeling
system is
on.)
The power • The batteries may be weak.
turns off Replace them.
when you
• Check that the batteries are
try to print.
correctly inserted.
• The wrong AC Adapter is used. We
recommend using the AD24
Adapter.
The tape
• Check that the end of the tape
does not
feeds under the tape guides. Refer
feed
to the Installing Power Supply
properly or
and Tape Cassette section in this
the tape
gets stuck
guide for an example.
inside the
• The Cutter Lever is pressed while
P-touch
printing. Do not touch the Cutter
labeling
Lever during printing.
system.
To change
• Refer to the Initial Settings section
language
in this guide.
setting.
Solution