Dometic 8700 Series Operation Manuals page 20

Installation
5.3 Toilet system with wall touchpad and through-the-floor connections
- all applications
1 . Place floor mounting template in desired location (fig .
walls or other interior fixtures are at least 11 in . (279 mm) away from centerline of template .
2 . Center punch all holes through template .
3 . Remove template from floor . Drill all access holes as indicated on template (fig .
4 . Plan flush switch panel and electronic control module locations so that electrical connections can
be made with cables provided . Be sure module and wires cannot get wet .
5 . Use Dometic wall switch template to mark location of fastener and access holes . Drill 1 in .
(25 mm) hole, then fasten panel bracket to wall (fig .
6 . Route Dometic flush switch panel cable (fig .
module to access hole at flush switch panel location . Attach cable to Dometic DFT flush switch
panel, then snap the panel cover onto the panel bracket (fig .
7 . Install control module in cool, dry location, then attach Dometic flush switch cable to ethernet
connector on control module (fig .
8 . With electrical power off, complete wiring connections to control module . Refer to wiring diagram
printed with parts list (packed separately) .
9 . Route 4-wire control module cable (fig .
10 . Route water supply and discharge plumbing to toilet according to system requirements (Section
4.2) . Make sure to provide extra discharge hose length to assure easy connection to toilet
(fig . 12 , page 9) .
8
Note
When installing Vimar or Gewiss flush switch/status panel,
disregard instructions for installing Dometic touchpad switch .
Install Vimar or Gewiss component on wall according to
manufacturer's instructions, then attach end of cable to 6-wire
connector (fig .
8
11 ) .
9
1
D, page 2) at control module .
Dometic 8700 Series MasterFlush Toilet
) . For optimal user comfort, make sure
8
) .
10
E, p . 2) from ethernet connector on control
1
1 D, page 2) to toilet through access hole in floor .
9
) .
10
10
11
) .