Advertisement
Quick Start
The UnoCart -2600 is an Atari cartridge emulator. It supports cartridges with up to 64k of ROM and 32k of RAM.
First, copy BIN, ROM or A26 files to an SD card and insert it into the cartridge. Check the TV configuration jumper on
the back of the board matches your TV system. Insert the cartridge in the Atari 2600. If the board is uncased, check
you've got it the right way round (see picture). Power on the Atari and use the joystick to choose an item and the
fire button to start it.
PAL/NTSC Configuration
The jumper on the back of the board allows you to select whether the cartridge uses NTSC or PAL/PAL60 for the
built-in menu. You can remove the jumper completely if you are using a NTSC TV.
Note that this jumper only applies to the cartridge menu (and also to the Supercharger BIOS if you are using a
Supercharger cartridge type). Once you select a ROM to emulate, the TV picture produced will be entirely
dependent on the cartridge being emulated. In general there were separate PAL and NTSC versions of each
cartridge – make sure you get the correct version.
SD Cards
SD cards should be formatted as FAT32. Newer SD cards may come formatted as exFAT. These can be used with the
UnoCart-2600, but need to be re-formatted as FAT32 on your computer prior to use. Note that the UnoCart-2600
firmware will only show up to 80 items per directory. You can use directories to organise your files.
1
Advertisement
