Table of Contents
Advertisement
4.5 Turning the Device On
The Micro-Z Mini™ is powered on by pressing
and releasing the On [|] / Active button for about
2 seconds until the display lights up with P1. Only
the "P" will be fl ashing. The Unit should be
connected to the garment electrodes and the
garment should be worn at this point.
4.6 Protocol Selection
When the unit is powered on, select desired
protocol P1 or P2 based on your clinician's
instructions (refer to Step 5 for more details).
Protocol selection is made by repeatedly pressing
the On [|] / Active button until the desired Protocol
is shown on the far left of the display, only the "P"
will be fl ashing.
4.7 Treatment Intensity
Two buttons on the device control intensity
Increase (L) and Decrease (M)
The intensity is always at fi ve when the device is
powered on or when the batteries have been
removed and replaced.
Press the Increase button to set the
protocol and intensity level. The "P" will stop
fl ashing and as you continue to press the button,
the intensity will increase and the LCD will
display the numeric value. The intensity will
increase in increments of 5, up to the maximum
intensity of 100. To decrease the intensity, press
the Decrease (M) button.
Note: The Increase and Decrease buttons
lock out after 20 seconds of nonuse so that
stimulation cannot be inadvertently changed
during treatment.
To reactivate the intensity controls, press
and release the On [|] / Active button. Intensity
controls will remain active for 20 seconds after the
last button was pressed.
4.8 Powering the Device Off
The Micro-Z Mini™ will automatically power off
when treatment is completed.
The Micro-Z Mini™ can be powered off manually
at any time. To manually power off, press the On
Active button for about 4 seconds and the device
will turn off. Or you may press and hold the
decrease button until the device reads 0, release
it and press it again and the device will turn off.
7
- Quick Links:
- Instructions for Use
Hide quick links:
Advertisement
Table of Contents
