Advertisement
OPERATION
Display Modes
AUTO CYCLE: By default, the unit is in AUTO-CYCLE mode. In AUTO-CYCLE
mode, the display will automatically cycle through current readings for
INDOOR (display) and OUTDOOR (sensor) temperature and humidity.
To enter AUTO-CYCLE mode, press and release the "SELECT" button on the
back of the display until the
again to exit AUTO-CYCLE mode.
MANUAL: While in Manual Mode, press and release the "SELECT" button,
located on the back of the display, to manually cycle through readings.
Troubleshooting
Problem
No outdoor sensor
reception
no bars
Inaccurate
temperature or
humidity
Display screen
not working
Outdoor
temperature
is flashing or
showing dashes
icon appears on the screen. Press and release
If the wireless signal indicator shows no bars:
• Relocate the display and/or the outdoor sensor. The
units must be within 165 ft (50 m) of each other.
• Make sure both units are placed at least 3 feet
(.9 m) away from electronics that may interfere with
the wireless communication (such as TVs, microwaves,
computers, etc).
• Use standard alkaline batteries (or lithium batteries in
sensor when temperature is below -4ºF/-20ºC). Do not
use heavy duty or rechargeable batteries.
take a few minutes for display and sensor to synchronize
after batteries are replaced.
• Make sure both the display and sensor are placed out of
direct sunlight and away from any heat sources or vents
(see page 5).
• Make sure both units are positioned away from moisture
sources.
• Check that the batteries are installed correctly. Batteries
may need to be replaced.
Flashing of the outdoor temperature is generally an
indication of wireless interference.
1. Bring both the sensor and display indoors and remove
batteries from each.
2. Reinstall the batteries in the wireless sensor.
3. Reinstall the batteries in the display.
4. Let the units sit within a couple feet of each other for a
few minutes to gain a strong connection.
6
Possible Solution
It may
NOTE:
Advertisement
