Download Print this page

Proteus ISS-500 Manual

Computer

Download this manual

Computer Manual - Proteus ISS-500

KEY GUIDE:

MODE

1. Select function and display on the screen during exercise.

Scan – Time – Calorie – RPM – Count.

2. Press this button to confirm the setting values of time, calorie and count.

3. Hold two seconds to reset all of values to zero.

Increase the setting value of the following functions.

Time – Calorie – Pulse – Count.

DOWN

Decrease the setting value of the following functions.

Time – Calorie – Pulse – Count.

ENTER

1. Press this button to enter setting mode.

2. Select function to be preset.

Time – Calorie – Pulse – Count.

3. Press this button to confirm the setting values of pulse.

1. Please install 2 pcs AA or UM-3 batteries in the battery case on the back of monitor.

2. Ensure that the batteries are correctly fitted. Battery must be correctly positioned and make sure the battery

spring is properly contacted with battery.

3. Should the displays appear blank or display only partial segments remove the batteries, wait 15 seconds, and

then replace again.

4. Whenever remove batteries, all the functional values will be to zero.

Page 1: Key Guide
Computer Manual - Proteus ISS-500 KEY GUIDE: MODE 1. Select function and display on the screen during exercise. Scan – Time – Calorie – RPM – Count. 2. Press this button to confirm the setting values of time, calorie and count.
Page 2 FUNCTION AND OPERATIONS AUTO ON/OFF The monitor will wake up automatically if the exercise machine is in motion. If stop exercising for over 4 minutes, monitor will turn off and reset all function values to zero. SCAN Press the button until the SCAN display on the screen. Monitor will display the following function and each function will keep 6 seconds on the screen.
Page 3 COUNT Press the button until the count display on the screen. Monitor will display the total counts on the screen. Count up: Without setting the count value, the monitor will count up from 0 ~ 9999. Count down: Setting the count from 10 ~9990, the monitor will count down from your setting values. Once reach setting value, monitor will alarm.