Proteus BC-8173II User Manual

SUMMARY :
This system is designed for programmable magnetic bike. There are 3 parts to this system
the monitor (BC-8173II), motor & controller and magnetic braking system.
A. Power up :
1. Before all, you should connect the connection cables with monitor together.
2. Install 4 UM-2 or R-14 batteries into the battery case on the back of monitor.
3. Batteries must be correctly positioned and mark sure the battery spring is properly
contacted with the batteries.
NOTE: The batteries must be removed from the appliance before it is scrapped
and they are disposed of safety.
4. If the power source is coming from ADAPTOR (6V 500mA), plug in the ADAPTOR.
NOTE: We strongly recommend using the adaptor, because power source is more
stable and continue than using batteries and you do not need to replace the batteries.
Pleas take off the batteries, if you would like to use the adaptor for a long period of
time.
5. After power up, all LCD segments will light up for 2 seconds & CPU will be reset the
resistance into level 1. And then the system goes into the initial mode. The displays will
be shown as fig. 2
**REMARK :
DO NOT CONNECT ANY ( AC, DC ) POWER SUPPLY
1. If the connection cables were installed incorrectly, monitor will display "E1" on matrix
display and generate a beep sound. Before asking service, please examine if all
connection cables are well connected and then reset the power to release the beep
sound or press " START / PAUSE (Hold to reset) " button to restart system.
2. Using a period of time, if the power source can't drive the motor and controller
smoothly, the monitor will display a sign of "E1". Please take out the batteries and wait
PROGRAMMABLE MAGNETIC EXERBIKE
MONITOR BC-8173II WITH LCD DISPLAY
BEFORE COMPLETELY ASSEMBLED
8173II