Download Print this page

Programming The Remote Control - Gira 0588 Series Operating Instructions Manual

Instabus / ir converter

Advertisement

Programming the remote control

N.B.: The EIB equipment which the
Instabus / IR converter is intended to control
or the EIB sensors controlling the Instabus /
IR converter must have been programmed
into the device beforehand during commis-
sioning.
If it is desired to control other consumers,
the device must be reprogrammed. For
reprogramming, the EIB commissioning
software (e.g. ETS3) is needed. In this case,
contact your electrical fitter.
For programming an IR remote control key
into the Instabus / IR converter proceed as
follows:
1. Slide the switch at the bottom of the
device into the 'LEARN' position. The IR
window is now lit up green.
2. Trigger the selected sensor function (e.g.
by depressing an EIB pushbutton briefly
or also for a longer time). The IR window
is now lit up orange.
3. Actuate the key of the remote control to
be programmed briefly two times.
The distance between the remote cont-
rol and the Instabus / IR converter
should be approx. 30...40 cm.
The IR window confirms the first key-
press by flashing orange once and the
second key-press by flashing orange
three times. After this cycle the window
shines green again.
4. Continue to program further IR channels
(step 2) or terminate the 'Learn' mode
(slide switch to position 'ON').
12
i
Important
• Make sure during programming of the IR
keys that the keys of the remote control
are pressed as briefly as possible. The IR
command will other-wise be stored re-
peatedly so that there may be mal-
functions.
• An IR window flashing three times red in-
dicates a fault.
The IR window shines green now. Repeat
the procedure with step 2 or abort (slide
switch to position 'ON').
• If the slide switch is in the 'LEARN' posi-
tion, and if no confirmation has been gi-
ven within 2 minutes, the Instabus / IR
converter terminates the procedure. The
IR window flashes green (in one-second
intervals) and the device has no function.
End the 'Learn' mode (slide switch in
pos. 'ON'.
• Note the key assignment of the IR remo-
te control.
Example
Remote
Key
control
TV
„darker"
Action
dining room
roof lamp off

Advertisement

loading