Bell Fibe Instructions

Bell
Fibe ™ TV
remote
instructions
Programming the remote to your TV
1. Turn on your TV and Fibe receiver.
2. Press and hold the options key for 3 seconds, until the green light
flashes twice. Within 10 seconds, enter the Ll-digit code for the
brand of your TV (see table below), or use 0001 to search through
all brands.
The green light will blink twice to confirm a correct entry. It will
light up for 2 seconds ii' an incorrect Ll digit code was entered. If no
code was entered with,n 10 seconds, start this step again.
TV Brand List
0010
Insignia
0011
Vizio
0012
RCA
0013
Sanyo
0014 Panasonic
0015
Funai/Emerson
0016
Sharp
0017
LG
0018
Toshiba
0019
Sony
0020
Samsung
0021
Philips
0022
Fluid
0001 search all brands
3. Hold down the power button until your TV turns off. This could
take up to 5 minutes for a popular brand or up to 15 minutes to
search through all brands. The green light will slowly blink as it
cycles through all the TV manufacturer codes.
Ll. Once your TV switches off, let go of the power button and press
the select key. The green light will blink twice to confirm it has been
successfully programmed.
Note:
If the green light blinks 5 times, it means the remote has searched
through the list of available codes, and hasn't found a match. If this
occurs, please start agoin at Step 2 and enter code 0001 to find an
alternate code which could work with your TV. If a correct code is
still not found, then the remote will control your Fibe receiver only.
For additional information and troubleshooting visit bell.ca/support.