Diamond SupraExpress 56e Manual page 65

#CLS=? Return the message, "0, 1, 2, or 8".
#CLS=0 Data. Similar to setting +FCLASS=0, and instructs the modem to act like a data
modem on subsequent answer or originate operations. When a disconnect or inactivity
timeout in the non-autobaud mode is detected, the modem automatically sets the
#CLS setting to 0 and hangs up. This ensures that the modem is always in a known
state despite disorderly DTE behavior.
#CLS=1 Class 1 fax. Similar to setting +FCLASS=1, and instructs the modem to be a Class 1
fax modem. Once set, either the +FAA or the +FAE command can be used to force
subsequent answers to be Class 1 adaptive answers.
#CLS=2 Class 2 fax. Similar to setting +FCLASS=2, and instructs the modem to be a Class 2
fax modem. Once set, the +FAA command can be used to force subsequent answers to
be Class 2 adaptive answers.
#CLS=8 Voice/Audio Mode. This is the main setting the DTE uses to effect directed or adaptive
answer or originate sequences involving voice modes. All telephone calls initialized by
#CLS=8 result (after answer or successful call progress) in the modem in Online
Voice Command Mode.
#LCD LCD Displays
#LCD=Ø,"STRING Mode disabled (default).
#LCD=1,"STRING String is displayed on LCD Line 1*.
#LCD=2,"STRING String is displayed on LCD Line 2*.
For example, if you issue: AT#LCD=1,"My fast Supra![CR] your modem will show MY
FAST SUPRA! on the top line. Or, if you issue:
AT#LCD=1,4D7920466173742053757072612021[CR] your modem will show MY
FAST SUPRA! on the top line. The AT parser causes all letters to be automatically converted to
upper case.
#LCD=Ø, hexstring ASCII hex Mode disabled (default).
#LCD=1,hexstring ASCII hex values displayed on LCD Line 1*.
#LCD=2,hexstring ASCII hex values displayed on LCD Line 2*.
*No CPU Cycles used for display in this mode. This allows all 255 ASCII characters to be used
on the display.
#VLS Voice Line Select
Selects which devices are routed through the modem.
#VLS? Display the current setting of the #VLS command as an ASCII decimal value in Result
Code format.
#VLS=?Request a report of the device types available, from 0 to 4.
#VLS=Ø Telephone Line with telephone handset (default.).
#VLS=1 Transmit/Receive Device (other than telephone line).
#VLS=2 Transmit Only Device. Normally the onboard speaker.
#VLS=3 Receive Only Device. Normally the microphone.
#VLS=4 Telephone line with Speaker ON and handset.
65