Diamond SupraExpress 56e Manual page 63

RX data rate =(now), min, max
On VFC & V.34 Connections these items are also reported:
Far Echo Delay (Round trip far end echo delay in mS.)
Far Echo Level (Signal Strength of far echo in dBm.)
Pre-Emphasis Filter (Filter in use to normalize the lines frequency response per ITU V.34
specs.)
On V.34 Connections these items are also reported:
Pre-Coding TX (0 no, 1 active) RX (0 no, 1 active)
Shaping TX (0 no, 1 active) RX (0 no, 1 active)
Non-linear encoding TX (0 no, 1 active) RX (0 no, 1 active)
Trellis mapping Type in use (16-4D, 32-4D, 64-4D)
SNR (Signal to Noise ratio measured during the line probe, in dB).
Normalized Bandwidth (The -3dB roll off points after the pre-emphasis filter is applied. This is
NOT the same as the usable audio band-width since the signal has been heavily processed prior
to this measurement. This range determines the maximum symbol rate the line will support.)
Symbol rate (Symbols per second on the connection)
TX Carrier - If the symbol rate is below 3429 there are two available carrier frequencies: a high
carrier and a low carrier. The actual frequency of the carriers varies with the symbol rate.
"High" or "Low" are the only items displayed. [33,600 bps connections require a 3429 symbol
rate.]
RX Carrier - Same as above on received carrier.
%Q2 Data Transfer Stats
(Current call or last call) On ALL Connections these items are reported:
Termination reason = (same as S86)
Transmitted Bytes =
Received Bytes =
On V.42 (LAPM) Connections these items are also reported:
Transmitted I frames =
Received I frames =
Bad frames received =
SREJs received =
REJs received =
SREJs transmitted =
REJs transmitted =
SREJ =(enabled/disabled)
Transmit window size =
Receive window size =
Transmit frame size =
Receive frame size =
On V.42bis (BTLZ) Connections these items are also reported:
BTLZ dictionary size =
BTLZ string length =
Octets =
Octets =
T401 resent I frames =
Resent I frames =
Resent I frames =
63