Advertisement
Pair the CameraLink
3
A. iPad setup – Make sure the CameraLink, SlingStudio Hub
and iPad with the SlingStudio Console app are close to
each other. Then open the Console app, go to Settings
and turn on WPS mode to connect to the CameraLink
automatically.
B. Mac setup – Make sure the CameraLink, SlingStudio Hub
and Mac with the SlingStudio Console app are close to
each other. Then open the Console app, go to Sources
» My CameraLink and turn on WPS to connect to the
CameraLink automatically.
The power LED will change from blinking red to solid white
when the CameraLink is successfully paired to SlingStudio.
These two devices will automatically connect with each
other from now on.
Optional:
•
Pair another CameraLink to your SlingStudio Hub – Repeat
the previous steps for each CameraLink.
•
Pair the CameraLink to another SlingStudio Hub – With
the CameraLink and the first SlingStudio Hub powered
on, unpair the CameraLink by pressing and holding the
CameraLink's power button for 10 seconds, until the
power LED blinks red. Then repeat step 3 above with the
second SlingStudio Hub.
•
Mount your CameraLink – Use the included hot shoe mount
to mount your CameraLink to your camera or tripod.
INTERNET
REC
SD
Advertisement
