Advertisement
Set-Up Instructions Continued
• Place the bottle on the base and close the door until it is in
the locked position.
• Ensure that the hot tank switch on back of unit is in the "Off"
position.
• Connect cooler to power source
cord). This water cooler is intended to be plugged into a
receptacle of the ground fault circuit interrupting type (GFCI).
• The AquaHostess™ has a self-priming feature that takes
approximately 5 minutes to fill both the hot and cold tanks.
After that time, dispense water from both the hot and cold
tanks to confirm that they have filled. Then turn on the hot
tank.
Note: The maximum water supply should not exceed 80 psi.
MTN Products
1770 Brackett Street
La Verne, CA 91750,
ACB210r-QSG
(do not use an extension
909-629-7301
Rev: 12/21/2015
MTN Products
AquaHostess™ (Bottle Water)
Quick Start Guide
Advertisement
Table of Contents
Related Manuals for MTN Products AquaHostess
Summary of Contents for MTN Products AquaHostess
-
Page 1: Quick Start Guide
This water cooler is intended to be plugged into a receptacle of the ground fault circuit interrupting type (GFCI). • The AquaHostess™ has a self-priming feature that takes approximately 5 minutes to fill both the hot and cold tanks. - Page 2 • Load a new bottle of water and push the dispense Button Descriptions button (#2) to resume normal operation. The no water indicator light (#1) will turn off. The cold water • Hot Water - Press the Hot button (#3 below) and hold light will stop flashing when the water reaches normal for 1 second (the unlock indicator ring will light-up red-- operating level.
Need help?
Do you have a question about the AquaHostess and is the answer not in the manual?
Questions and answers