Holland FWS1 Series Owner's Manual page 16

Maintenance Procedures
5. Rotate lock tester out of the way and
measure distance between scribed lines.
If distance between lines exceeds 1/8",
the lock should be adjusted tighter
(Figure 30).
6. To adjust lock:
With lock tester still locked in fifth

wheel, lift up on fifth wheel ramps
and rotate fifth wheel to its forward
most position (towards cab).
Remove clinch pin from bottom of

lock adjustment pin (Figure 31).
Lift lock adjustment pin and rotate

clockwise to the next adjustment
position shown on the face of fifth
wheel (Figure 32).
Push lock adjustment pin into fifth

wheel in the new position.
Replace clinch pin.

7. Re-check for free play in the locks by
repeating Steps 3-5. If free play still
exceeds 1/8", repeat Step 6 and rotate
lock adjustment pin one more notch.
NOTE: If free play greater than
1/8" remains with the lock
adjustment pin on the last
(fourth) position, then the fifth
wheel should be rebuilt using
rebuild kit RK-FWS-A-L.
14
XL-FW10054UM-en-US Rev C· 2018-01-29 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
Figure 30
MEASURE DISTANCE
BETWEEN LINES
Figure 31
CLINCH PIN
Figure 32
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.