Disclaimer; Cautions; Installation Note; Precautions For Use - FPV Model T20 User Manual

Disclaimer

Thank you for choosing T20 All-in-one handheld ground station.（Hereinafter to
be referred as "T20". Please use T20 according to your local radio regulation. Please
read this statement carefully before use. It is deemed as acceptance of the entire
contents of this statement,once the product has been used.Please strictly follow
this instruction to install and use the product. FPV MODEL Co., Ltd. do not accept
any legal responsibility and will not be liable for any result or loss caused by
improper use, installation, assembly or modification of users.

Cautions

When using the T20, if it is not operated properly, the aircraft may cause a certain
degree of injury or damage to property. Please be careful when using it.

Installation note

1. Be sure to use the parts provided by FPV MODEL.
2. Be sure to install the antenna before power on to avoid damage to
the circuit.
3. Be sure the antenna is not obstructed by any obstacles and the end of the
antenna is facing down vertically and no bent, to avoid the communication
distance being shortened, or even unable to communicate.
4. Do not disassemble or modify the T20. If you encounter any problems that
cannot be solved during the installation process, please contact FPV MODEL
Co., Ltd. or your local distributor.
5. Be aware of the proper distance between all the electronic devices during
installation, to minimize the electromagnetic interference between the
devices.

Precautions for Use

1. Before use, please make sure all the connecting wires are tight and all parts
are working properly.
2. Please open the remote controller configuration software and check if the
channels are all working after booting.
3. Please check the surrounding environment to ensure that there are no
other device interference in 840MHz-930MHZ , otherwise T20 data
transmission performance may be seriously affected.
4. Check the remote controller battery before use. If the battery is lower than
25%, please recharge the remote controller. If the remote control is turned off,
the receiver will go out of control.
1