Introduction The MicroAire REF 7500-700 Battery Charger has been designed to charge all MicroAire 14 . 4 volt NiMH battery packs . This manual has been written to help describe the procedures required to keep the MicroAire Battery Charger system operating properly .
. ALWAYS decontaminate a battery pack exposed to infectious material before sending it to a waste treatment facility . European Conformity Mark with MicroAire’s Notified Body Number MEDICAL-GENERAL MEDICAL EQUIPMENT AS TO ELECTRIC SHOCK, FIRE, AND MECHANICAL HAZARDS ONLY .
OPERATION 1 . Verify that the “Standby” LED is on . 2 . Insert a MicroAire REF 6640-710 or REF 7505- 710 Battery into any slot . The battery can only be inserted on the charger in one position .
. SERVICES AND REPAIR Periodic inspection and factory service is essential to keep precision MicroAire instruments running properly . If repairs are required, they can be accomplished quickly with a minimum of disruption to the hospital’s schedule .
Page 7
All MicroAire equipment should be inspected and tested periodically in accordance with the facility’s Bio-Engineering policy . Such service should be documented within the Bio-Engineering Department . MICROAIRE REPAIR SERVICE Responsive service comes with every MicroAire product . If a problem arises, contact our Customer Service Department at: USA: (800) 722-0822 / (434) 975-8000 Fax: (434) 975-8010 inquiry@microaire .com...
The MicroAire REF 7500-700 Battery Charger system is intended for use in the electromagnetic environment specified below . The customer or the user of the MicroAire REF 7500-700 Battery Charger system should assure that it is used in such an environment .
Page 9
The MicroAire REF 7500-700 Battery Charger system is intended for use in the electromagnetic environment specified below . The customer or the user of the MicroAire REF 7500-700 Battery Charger system should assure that it is used in such an environment .
Page 10
The MicroAire REF 7500-700 Battery Charger system is intended for use in the electromagnetic environment specified below . The customer or the user of the MicroAire REF 7500-700 Battery Charger system should assure that it is used in such an environment .
Page 11
The MicroAire REF 7500-700 Battery Charger system is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled . The customer or the user of the MicroAire REF 7500-700 sys- tem can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and the MicroAire REF 7500-700 system as recommended below, according to the maximum output power of the communications equipment .
Need help?
Do you have a question about the 7500-700 and is the answer not in the manual?
Questions and answers