Advertisement
TO INTERRUPT PLAYBACK
Press the PLAY/PAUSE
button once during playback. Playback stops and the track
display flashes. Press the PLAY/PAUSE
button again to cancel pause and resume
playback at the same point in the track. The track display stops flashing.
TO STOP PLAYBACK
Press the STOP
button and the display
shows the total tracks of the disc.
STOP
NOTE: After pressing the STOP
button wait a few seconds for the disc to stop completely
before opening the CD door.
TO SKIP TO THE BEGINNING OF A TRACK
• Press either one of the
REV /
FWD skip buttons according to the desired skip p
direction.
• Playback resumes from the selected track.
• When the
FWD button is pressed once during playback, the player advances to the
beginning of the next track.
• When the
REV button is pressed once during playback, the player returns to the
beginning of the track being played. To back up to the beginning of the previous track
press the button twice.
SEARCHING FOR A PASSAGE WITHIN A TRACK
• Keep the
FWD or
REV button pressed during playback, and release the button
as soon as you recognize the desired passage. Normal CD playback will resume from
this point.
REV.
SKIP
FWD.
SEARCH
8
REPEAT PLAYBACK
This function allows a single track or all tracks on a disc to be played repeatedly.
TO REPEAT THE SAME TRACK
TO REPEAT THE WHOLE DISC
Press the REPEAT button once during
Press the REPEAT button twice until
playback. The CD display will indicate
" REPEAT ALL " displays.
" REPEAT ".
REPEAT
R E P E AT
REPEAT
ALL
TO CANCEL REPEAT PLAYBACK FUNCTION
Press the REPEAT button again until " REPEAT " or " REPEAT ALL " disappears from the
display.
REPEAT
9
PROGRAMMED PLAYBACK
Programmed playback enables tracks on a disc to be played in any desired order.
Up to 20 tracks can be programmed.
NOTE : Programming can only be done when the player is in Stop mode.
1.) Press the PROGRAM button. "PROGRAM" indicator flashes in the display.
P R O G R A M
PROGRAM
2.) Press the
FWD or
REV button to select the desired track number. .
Example: Track 7.
P R O G R A M
REV.
SKIP
FWD.
SEARCH
3.) Press PROGRAM button again to memorize the track.
4.) Repeat steps 2 and 3 until all desired tracks are programmed.
5.) Press the PLAY/PAUSE
button to start playback.
"PROGRAM " indicator is flashing in the CD display.
PLAY
P R O G R A M
6.) Press STOP
button to stop programmed playback. The CD playback stops
but the program remains in the memory.
7.) Press PROGRAM and PLAY/PAUSE
buttons to resume programmed
playback.
8.) To clear the program memory, open the CD door, change to Radio function or
switch the power 'OFF'.
10
CARE AND MAINTENANCE
COMPACT DISC CARE
• To remove a disc from its storage case, press down on the center of the case
and lift the disc out, holding it carefully by the edges.
• Treat the disc carefully. Handle the disc only by its edges. Never allow your
fingers to come in contact with the shiny, unprinted side of the disc.
• Do not attach any tape, stickers, etc. to the disc label.
• Clean the disc periodically with a soft, lint-free, dry cloth. Never use detergents
or abrasive cleaners to clean the disc. If necessary, use a CD cleaning kit.
• If a disc skips or gets stuck on a section of the disc, it is probably dirty or
damaged (scratched).
• When cleaning the disc, wipe in straight lines from the center of the disc to the
outer edge of the disc. Never wipe in circular motions.
11
CLEANING THE UNIT
• To prevent fire or shock hazard, disconnect your unit from the AC power source
when cleaning.
• If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any
wax or polish sprays on the cabinet.
• If the cabinet becomes dirty or smudged with fingerprints it may be cleaned
with a soft cloth slightly dampened with a mild soap and water solution. Never
use abrasive cloths or polishes as these will
scratch
the finish of your unit.
CAUTION:
Never allow any water or other liquids to get inside the unit while cleaning.
12
TROUBLESHOOTING GUIDE
Should this unit exhibit a problem, check the following before seeking service.
Symptom
Possible Cause
Solution
Radio
Noise or sound
Station not tuned properly for
Retune the AM or FM
distorted on AM or FM
AM or FM.
broadcast station.
broadcasts.
FM: Rod antenna is not
Extend FM Rod antenna.
extended.
AM: The bar antenna is not
Reposition the unit until
positioned correctly.
best reception is obtained.
AM or FM no sound.
Function switch is not set to
Set function switch to
AM or FM.
AM or FM.
Volume at minimum.
Increase Volume.
Compact Disc Player
CD Player will not play.
Function switch is not set to
Set unction switch to
CD.
CD.
CD is not installed or installed
Insert CD with Iabel side
incorrectly.
facing out.
CD skips while playing.
Disc is dirty or scratched.
Wipe disc with cloth or use
another disc.
FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE
PLEASE CALL:
1-800-898-9020 OR
1-800-695-0098 OR
E-MAIL TO: internet @ emersonradio.com
13
PD5098-904-01
Printed in China
Advertisement
