Chapter 3 Operation; Operating Notes; Q-See Compliant Thumbnails; Activating Hmx6803+ And Op+Hmx+ Functions - Imagine communications HMX6803 Plus Installation And Operation Manual

3
Operation
Operating
When you set the control parameters on the HMX6803+ and OP+HMX+, observe the
following:
Notes



Q-SEE Compliant Thumbnails

When installed in an FR6802+QXF or FR6822+ frame that also contains a 6800+ETH
resource module, HMX6803+ and OP+HMX+ module control windows have an extra
Streaming tab in CCS Pilot and Navigator (version 3.2.1 or later). There you can view
output video from the module.
In addition, video from the HMX6803+ and OP+HMX+, displayed at up to three frames per
second, can be displayed on the 6800+ETH's control page, and (for CCS Navigator only) on
Graphical Navigation pages.
Note: HMX6803+ and OP+HMX+ modules all show a HMX6803+ label in Navigator.
Thumbnail streaming is not supported for the following video standards:






Activating HMX6803+ and OP+HMX+ Functions

The following sections provide information about the HMX6803+ and OP+HMX+ special
functions:
If you make changes to certain parameters, other related parameters may also be
affected. See Cross-Functional Parameter Changes
information.
When you change a parameter, the effect is immediate. However, the module requires
up to 30 seconds to save the latest change. After 30 seconds, the new settings are
saved and will be restored if the module loses power and must be restarted.
1080i 60
720p 60
1080p 24/25/29.97/30
1080psF 23.98/24
1080p 50/59.94/60
on page 32 for more
21